Connecting The Network Cable - Honeywell EK280 Applications Manual

EK280
Specification
Cable design:
Conductor material
Strands (per core)
Cross-section
Number of cores
Core layout
Core pair screen
Colour sequence of cores – core
pairs
Screen
Total screen
Degree of screen coverage
Sheath material
Sheath diameter
Plugs
The pin assignment of the network cable complies with EIA/TIA 568B.

7.2.2 Connecting the network cable

Attention! Danger of death!
The mains voltage must be switched off before opening the housing of the EK280.
Ensure it is not turned back on and verify that there is no voltage.
Attention!
Always switch off the PoE power supply before connecting the network cable and
secure it against being switched on again!
The safest way is to remove the network cable from the switch or the network socket.
Application Manual
multi-wire tin-plated copper conductor
7
4 × 2 × AWG 26/7 (4 × 2 × 0.128 mm²)
8
twisted pair
aluminum foil
in accordance with EIA/TIA 568B
SF/UTP
braid made from copper wires
min. 60%
PUR
5.8 mm ± 0.2 mm
left: RJ45 IP20, right: RJ45 IP20
90