EK280
6.7 Continuous pulse output
Each of the outputs 1 to 4 (terminals DA1 to DA4) can emit continuous pulses for testing purposes.
6.7.1 Parameterization
Parameterization is carried out via the keyboard on the EK280.
Alternatively, parametrization can be carried out using the enSuite program. The paths which are
subsequently described can be found in enSuite under
a) Setting up the output mode:
−
Move the cursor to the tab "Serv." and subsequently via the following path to the mode for the
corresponding output "Md.O1" to "Md.O4":
Serv.
Outputs
Serv.
Outputs
Serv.
Outputs
Serv.
Outputs
−
Press the ENTER key. ⇒ The set value flashes.
−
Press one of the arrow keys or until the "cont.pulse" text flashes.
−
Press the ENTER key to confirm the set value. It is possible to abort the entry by pressing the ESC
key.
6.8 Switching pulse inputs on or off
Each of the outputs 1 to 4 (terminals DA1 to DA4) can be permanently switched off (transistor closed, "switch
open") or switched on (transistor conducts, "switch closed").
6.8.1 Parameterization
Parameterization is carried out via the keyboard on the EK280.
Alternatively, parametrization can be carried out using the enSuite program. The paths which are
subsequently described can be found in enSuite under
a) Setting up the output mode:
−
Move the cursor to the tab "Serv." and subsequently via the following path to the mode for the
corresponding output "Md.O1" to "Md.O4":
Serv.
Outputs
Serv.
Outputs
Serv.
Outputs
Serv.
Outputs
−
Press the ENTER key. ⇒ The actual parameterized value flashes.
−
Press down one of the arrow keys or press repeatedly until the text "off" or "on" flashes.
−
Press the ENTER key to confirm the set value. It is possible to abort the entry by pressing the ESC
key.
Application Manual
Output 1
Md.O1
Output 2
Md.O2
Output 3
Md.O3
Output 4
Md.O4
Output 1
Md.O1
Output 2
Md.O2
Output 3
Md.O3
Output 4
Md.O4
"Parameterize
online" > "Parameters".
"Parameterize
online" > "Parameters".
54