Honeywell EK280 Applications Manual page 126

EK280
7.4.6.2 Parameterization of the GPRS/TCPserv modems in the FE260
i
Parameterization as described for the GSM/GPRS modem in the FE260 is only required, if the
FE260 is fitted with a modem into which the modem application "ComTCPserv" has been loaded
with:
− Either the Integra M2106 with the sticker illustrated on the right:
If another sticker has been affixed to the M2106, or another
modem application is marked, the modem cannot be used for
the "GPRS-TCPserv" application!
Or ECM-GW120 with the sticker illustrated on the right.
−
Note:
For the application "TCPserv" used with the EK280 plus the
FE260 and the integrated ECM-GW120, the normal modem
application used is "WipSoft", because there is no need for a
separate modem parameterization. Inputting the VPN access data into the EK280 with
enSuite is sufficient for proper function of the "TCPserv" feature. The EK280 sets these
data at the beginning of each time window with ECM-GW120 ( chapter 7.4.6.1).
However, in practice there is the possibility that the modem application "ComTCPserv" is
loaded into ECM-GW120 instead of "WipSoft". This can happen, for example, if the
FE260 has been previously used with an EK260 which is now being swapped for an
EK280. Since it was not possible to store the VPN access data in the EK260, it could
only be used for TCPserv applications with the modem application "ComTCPserv"!
i
If the FE260 includes an ECM-GW120 with the sticker shown on the right
or an ECM-xG-Uxxxx, it does need not to be parameterized separately.
In this case, the function is set by entering the parameters in the EK280
in accordance with  chapter
Parameterization of the modem application "ComTCPserv" in the GSM/GPRS modem may be effected either
through a GSM-CSD modem connection or on location, with the FE260 housing open and a switched 230
VAC on supply. However, the latter operated must only be performed by suitably qualified persons.
CAUTION! 230 V alternating voltage! Risk to life!
i
For the parameterization of the GPRS-ComTCPserv modems in the FE260for operation with an
EK280 you need a commercially available DSUB9-RS232 cable (1.1 through contacted, not a
null modem cable) or a GSM/CSD connection as well as the software enSuite from V3.9 and
higher, which is available for downloading free of charge from www.elster-instromet.com.
i
For parameterization of the modem application "ComTCPserv" in an FE260 there is also a
separate commissioning instruction (ID-No. 73021404) 0, which is included with every FE260
with a ComTCPserv modem.
For parameterization of the GPRS-ComTCPserv modem in the FE260 please proceed as follows.
Application Manual
7.4.6.1 EK280 Parametrization (p. 121).
124