Honeywell EK280 Applications Manual page 94

EK280
7.2.2.5 Pushing the cable screen over the cone
Spread out the braid some more and push the cone under the screen. Then slide the cone from the sheath
onto the part of the cable with the sheath removed and carefully push it under the screen ( Figure below).
i
Make sure that the screen is evenly spread over the entire circumference of the cone.
7.2.2.6 Placing the retaining ring and assembling the cable gland
− Push the retaining ring over the cone.
Make sure that the screen is pushed up to the collar on the cone ( Fig.).
Slide the cone with the retaining ring into the threaded insert of the cable gland.
−
− Then carefully insert the sealing insert.
− Screw on and tighten the union nut.
7.2.2.7 Removing the foil screen
− The foil screen can be splayed by slightly twisting it.
Cut off the foil screen near the gland with diagonal pliers.
7.2.2.8 Stripping cores and fitting with ferrules
− The cores are now stripped over a length of 7 mm and fitted with ferrules.
For this, use 0.14 mm × 6 ferrules and ferrule crimping pliers (ideally self-adjusting crimping pliers
for ferrules). The ferrules can be in any colour.
Application Manual
(1) Slide on the retaining ring.
(2) Push the sealing insert afterwards.
(3) The screen should end here.
92