Lateral Rod; Rear Axle Housing - Suzuki SQ416 Service Manual

3E-4 REAR SUSPENSION
(a)
1
2

1. Rear axle housing

2. Spring seat
3. Coil spring
4. Stepped part
1. Body center

LATERAL ROD

REMOVAL
1) Hoist vehicle.
2) Remove lateral rod mounting bolts.
3) Remove lateral rod.
1. Bolt
2. Washer
3. Lateral rod
INSTALLATION
1) Install lateral rod to rear axle, and vehicle body.
2) Lower hoist.
3) Tighten lateral rod mounting bolts to specified torque.
Tightening Torque
(a)
(a): 100 N
REAR AXLE HOUSING
INSTALLATION
Install removed parts in reverse order of removal, noting the follow-
ing.
1) Place rear axle housing on floor jack. Then install upper/lower
rod rear mounting bolts (right & left) in proper direction as shown
(refer to UPPER ROD INSTALLATION for upper rod bolts). At
this time, mount nuts but don't tighten them.
1. Lower rod
2. Body center
2) Install coil spring (right & left) on spring seat of axle housing and
raise axle housing.
NOTE:
When seating coil spring, mate spring end with stepped
part of rear axle spring seat as shown.
3) Install lateral rod to rear axle housing.
4) Install lower part of shock absorber to right and left sides of axle
housing and install bolts in proper direction as shown in figure.
At this time, mount nuts but don't tighten them.
1
.
m (10.0 kg-m, 72.5 lb-ft)