Wheel/Hub Inspection
\
Bearing End Play
1. Raise the vehicle off the ground, and suppon it wjth
safety stands in the proper locations (see section 1).
2.
Remove the wheels, then reinstallthe wheel nuts
3.
Attach the dial gauge as shown.
4.
N4easure the bearing end play by moving the disc in
or outward.
Front/R€ar:
Standard: 0 - 0.05 mm l0 - 0.002 inl
Measure end play at
hub flange.
t . /
Bear:
M e a s u r e e n d P l a Y a t c e n t e r o f
t h e h u b c a p .
lf the bearing end play measurement is
the standard, replace the wheel bearing.
l J
more than
1 A - 7
Wheel Runout
1. Raise the vehicle off the ground, and support it with
safety stands in the proper locations (see section I I
2.
Check for bent or deformed wheels.
3.
Attach the dial gauge as shown.
4.
Measure the wheel runout by turning the wheel.
Front and Rear Wheel Axisl Runout:
Standard:
Steel Whoel:
0 - 1.0 mm (0 - 0.0,1 inl
Aluminum Wheel: 0 - 0.7 mm (o - 0.03 in)
Servica Limit:
2.0 mm (0.08 inl
Front and Rear Wheel Radill Runout:
Standard:
Steol Wheel:
0 - 1.0 mm (0 - 0.04 in)
Aluminum Wheol: 0 - 0.7 mm (0 - 0.03 in)
Service Limit:
1.5 mm {0.06 in}
lf the wheel runout is more than the service limit,
replace the wheel.