Reassembly - Honda Civic Service Manual

Rear Damper
Disassembly/lnspection (cont'dl
SELF-LOCK|NG NUT
- el
10 x 1.25 mm
v
29 N.m {3.0 kst'm, 22 lbf.ftl
Replace.
DAMPEB
MOUNTING
WASHER
DAMPER MOUNTING
8U8BER
Check tor
deterioration
ano oamage.
DAMPER
COLLAR
DAMPER
MOUNTING BASE
OAMPER MOUNTING
DAMPER SPRING
Check lor weakness,
compression, and damage.
SPRING MOUNTING
RUBBER
Check for deterioration
ano oamage.
BUMP STOP
Check for weakness
and damage,
BUBBES
Check for
deterioration
ano oamage.
OUST COVER PLATE
DUST COVER
Check lor bending
DUST COVER BOOT
Check for deterioration
and damage.
18-2A
OAMPER UNIT
R e p l a c e .
:
Reassembly
1 . Install the damper unit onto a spring compressor.
NOTE: Followthe manufacturer's instructions.
Assemble the rear damper in the reverse order of
disassembly except the damper mounting washer
and self-locking nut.
NOTE: Align the bottom of the damper spring and
spring lower seat as shown.
P o s i t i o n t h e d a m p e r m o u n t i n g b a s e o n t o t h e
damoer unit as shown.
SIRUT SPRING COMPRESSOR:
DAMpERMOUNTTNG (Commerciattyavaitabtel
BRANICKO T/N MST-580A, T/N 7200.
or cquivalont
Compress the damper spring with the spring com-
pressor.
Install the damper mounting washer, and loosely
install a new self-locking nut.
Hold the damper shaft with a hex wrench, and tight-
en the self-locking nut.
SELF-LOCKING NUT
DAMPER
10 x 1,25 mm
29 N m 13.0 kgt.m, 22 lbtftl
MOUNTING
WASHER