Vlan Filter - Cisco 4500M Command Reference Manual

vlan filter

vlan filter
To apply a VLAN access map, use the vlan filter command. To clear the VLAN access maps from
VLANs or interfaces, use the no form of this command.
Syntax Description
map-name
vlan-list vlan-list
Defaults
This command has no default settings.
Command Modes
Global configuration
Command History Release
12.1(12c)EW
Usage Guidelines
When configuring an action clause in a VLAN access map, note the following:
•
•
•
When entering the no form of this command, the vlan-list parameter is optional (but the keyword
vlan-list is required). If you do not enter the vlan-list parameter, the VACL is removed from all VLANs
where the map-name is applied.
Examples
This example shows how to apply a VLAN access map on VLANs 7 through 9:
Switch(config)# vlan filter ganymede vlan-list 7-9
Switch(config)#
Catalyst4500 Series SwitchCiscoIOS Command Reference—Release 12.2(18)EW
2-502
vlan filter map-name {vlan-list vlan-list}
no vlan filter map-name {vlan-list [vlan-list]}
VLAN access-map tag.
VLAN list; see "Usage Guidelines" for valid values.
Modification
Support for this command was introduced on the Catalyst 4500 series switch.
You can apply the VLAN access map to one or more VLANs.
The vlan-list parameter can be a single VLAN ID, a list of VLAN IDs, or VLAN ID ranges
(vlan-id-vlan-id). Multiple entries are separated by (-) (hyphen) or (,) (comma).
You can apply only one VLAN access map to each VLAN.
Chapter2 Cisco IOS Commands for the Catalyst 4500 Series Switches
78-16201-01