udld reset
udld reset
To reset all UDLD ports in the shutdown state, use the udld reset command.
Syntax Description
This command has no keywords or variables.
Defaults
This command has no default settings.
Command Modes
Privileged EXEC
Command History
Release
12.1(8a)EW
Usage Guidelines
If the interface configuration is still enabled for UDLD, these ports will begin to run UDLD again and
may shut down if the reason for the shutdown has not been corrected.
The udld reset command permits traffic to flow on the ports again; other features, such as spanning tree,
PAgP, and DTP, operate n ormally if enabled.
Examples
This example shows how to reset all ports shut down by UDLD:
Switch# udld reset
Switch#
Related Commands
show udld
Catalyst4500 Series SwitchCiscoIOS Command Reference—Release 12.2(18)EW
2-490
udld reset
Modification
Support for this command was introduced on the Catalyst 4500 series switch.
Chapter2
Cisco IOS Commands for the Catalyst 4500 Series Switches
78-16201-01