Cisco 4500M Command Reference Manual page 288

show dot1x
This example shows how to display 802.1x statististics for a specific port:
Switch# show dot1x interface fastethernet3/2
AuthSM State
BendSM State
PortStatus
MaxReq
MultiHosts
Port Control
QuietPeriod
Re-authentication = Disabled
ReAuthPeriod
ServerTimeout
SuppTimeout
TxPeriod
Guest-Vlan
Switch#
Note
Table2-12
state information. For a detailed description of these state machines and their settings, refer to the IEEE
802.1X specification.
Table2-12 show dot1x interface Field Description
Field
PortStatus
Port Control
MultiHosts
This is an example of output from the show dot1x statistics interface gigabitethernet1/1 command.
Table2-13
Switch# show dot1x statistics interface gigabitethernet1/1
PortStatistics Parameters for Dot1x
--------------------------------------------
TxReqId = 0
RxStart = 0
RxInvalid = 0
RxVersion = 0
Switch#
Table2-13 show dot1x statistics Field Descriptions
Field
TxReq/TxReqId
TxTotal
RxStart
RxLogoff
Catalyst4500 Series SwitchCiscoIOS Command Reference—Release 12.2(18)EW
2-256
= AUTHENTICATED(GUEST_VLAN)
= IDLE
= AUTHORIZED
= 2
= Disabled
= Auto
= 60 Seconds
= 3600 Seconds
= 30 Seconds
= 30 Seconds
= 30 Seconds
= 91
provides a partial list of the displayed fields. The remaining fields in the display show internal
Description
Status of the port (authorized or unauthorized). The status of a port is
displayed as authorized if the dot1x port-control interface configuration
command is set to auto and has successfully completed authentication.
Setting of the dot1x port-control interface configuration command.
Setting of the dot1x multiple-hosts interface configuration command
(allowed or disallowed).
describes the fields in the display.
TxReq = 0 TxTotal = 0
RxLogoff = 0 RxRespId = 0
RxLenErr = 0 RxTotal= 0
LastRxSrcMac 0000.0000.0000
Description
Number of EAP-request/identity frames that have been sent.
Number of EAPOL frames of any type that have been sent.
Number of valid EAPOL-start frames that have been received.
Number of EAPOL-logoff frames that have been received.
Chapter2 Cisco IOS Commands for the Catalyst 4500 Series Switches
RxResp = 0
78-16201-01