Vtp V2-Mode - Cisco 4500M Command Reference Manual

vtp v2-mode

vtp v2-mode
To enable version 2 mode, use the vtp v2-mode command. To disable version 2 mode, use the no form
of this command.
Syntax Description
This command has no arguments or keywords.
Defaults
Disabled
Command Modes
VLAN configuration
Command History Release
12.1(8a)EW
Usage Guidelines
All switches in a VTP domain must run the same version of VTP. VTP version 1 and VTP version2 do
not operate on switches in the same VTP domain.
If all switches in a domain are VTP version 2-capable, you only need to enable VTP version 2 on one
switch; the version number is then propagated to the other version 2-capable switches in the VTP
domain.
If you toggle the version 2 mode, parameters of certain default VLANs will be modified.
Examples
This example shows how to enable version 2 mode in the VLAN database:
Switch(vlan-config)# vtp v2-mode
Switch(vlan-config)#
This example shows how to disable version 2 mode in the VLAN database:
Switch(vlan-config)# no vtp v2-mode
Switch(vlan-config)#
Related Commands
show vtp
vtp (global configuration mode)
Catalyst4500 Series SwitchCiscoIOS Command Reference—Release 12.2(18)EW
2-516
vtp v2-mode
no vtp v2-mode
Modification
Support for this command was introduced on the Catalyst 4500 series switch.
Chapter2 Cisco IOS Commands for the Catalyst 4500 Series Switches
78-16201-01