Show Interfaces Capabilities - Cisco 4500M Command Reference Manual

show interfaces capabilities

show interfaces capabilities
To display the interface capabilities for an interface or for all the interfaces on a switch, use the show
interfaces capabilities command.
Syntax Description
module mod
interface
interface-number
Defaults
This command has no default settings.
Command Modes
Privileged EXEC
Command History Release
12.1(19)EW
Usage Guidelines
The interface-number variable designates the module and port number. Valid values for
interface-number depend on the chassis and module used. For example, if you have a 48-port
10/100-Mbps Fast Ethernet RJ-21 ( telco connector) switching module installed in a Catalyst 4507
chassis, valid values for the slot number are from 2 to 13 and valid values for the port number are 1 to 48.
Examples
This example shows how to display interface capabilities for a module:
Router# show interfaces capabilities module 1
GigabitEthernet1/1
Model:
Type:
Speed:
Duplex:
Trunk encap. type:
Trunk mode:
Channel:
Broadcast suppression:percentage(0-100), hw
Flowcontrol:
VLAN Membership:
Fast Start:
Queuing:
CoS rewrite:
ToS rewrite:
Catalyst4500 Series SwitchCiscoIOS Command Reference—Release 12.2(18)EW
2-276
show interfaces capabilities [{module mod}]
show interfaces [interface interface-number ] capabilities
(Optional) Keyword and variable to display information for the specified
module only.
(Optional) Specifies the interface type. Valid values are fastethernet,
gigabitethernet, and port-channel .
(Optional) Specifies the port number.
Modification
Support for this command was introduced on the Catalyst 4500 series
switch.
WS-X4516-Gbic
Unsupported GBIC
1000
full
802.1Q,ISL
on,off,desirable,nonegotiate
yes
rx-(off,on,desired),tx-(off,on,desired)
static, dynamic
yes
rx-(N/A), tx-(4q1t, Sharing/Shaping)
yes
yes
Chapter2 Cisco IOS Commands for the Catalyst 4500 Series Switches
78-16201-01