L2Protocol-Tunnel Cos - Cisco 4500M Command Reference Manual

l2protocol-tunnel cos

l2protocol-tunnel cos
To configure the class of service (CoS) value for all tunneled Layer 2 protocol packets, use the
l2protocol-tunnel cos command. Use the no form of this command to return to the default value of zero.
Syntax Description
value
Defaults
The default is to use the CoS value configured for data on the interface. If no CoS value is configured,
the default is 5 for all tunneled Layer 2 protocol packets.
Command Modes
Global configuration
Command History Release
12.2(18)EW
Usage Guidelines
When enabled, the tunneled Layer 2 protocol packets use this CoS value.
The value is saved in NVRAM.
Examples
This example shows how to configure a Layer-2 protocol tunnel CoS value of 7:
Switch(config)# l2protocol-tunnel cos 7
Switch(config)#
Related Commands
l2protocol-tunnel
l2protocol-tunnel drop-threshold
l2protocol-tunnel shutdown-threshold
Catalyst4500 Series SwitchCiscoIOS Command Reference—Release 12.2(18)EW
2-158
l2protocol-tunnel cos value
no l2protocol-tunnel cos
Specifies the CoS priority value for tunneled Layer 2 protocol packets. The range is 0 to 7,
with 7 being the highest priority.
Modification
This command was first introduced on the Catalyst 4500 series switch.
Chapter2 Cisco IOS Commands for the Catalyst 4500 Series Switches
78-16201-01