Show Redundancy - Cisco 4500M Command Reference Manual

Chapter2 Cisco IOS Commands for the Catalyst 4500 Series Switches

show redundancy

To display redundancy facility information, use the show redundancy command.
Syntax Description
clients
counters
history
states
Defaults
This command has no default settings.
Command Modes
Privileged EXEC
Command History Release
12.1.(13)EW
Examples
This example shows how to display redundancy facility client information:
Switch# show redundancy clients
clientID = 0
clientID = 30
clientID = 28
clientID = 65000
The output displays the following information:
•
•
•
This example shows how to display the redundancy facility counter information:
Switch# show redundancy counters
Redundancy Facility OMs
rx peer msg routing errors = 0
78-16201-01
show redundancy {clients | counters | history | states}
Displays the redundancy facility client information.
Displays the redundancy facility counter information.
Displays a log of past status and related information for the redundancy facility.
Displays the redundancy facility state information.
Modification
Support for this command was introduced on the Catalyst 4500 series switch
(Catalyst 4507R only.)
clientSeq = 0
clientSeq = 135
clientSeq = 330
clientSeq = 65000
clientID displays the client's ID number.
clientSeq displays the client's notification sequence number.
Current redundancy facility state.
comm link up = 1
comm link down down = 0
invalid client tx = 0
null tx by client = 0
tx failures = 0
tx msg length invalid = 0
client not rxing msgs = 0
null peer msg rx = 0
Catalyst4500 Series SwitchCiscoIOS Command Reference—Release 12.2(18)EW
RF_INTERNAL_MSG
Redundancy Mode RF
GALIOS_CONFIG_SYNC
RF_LAST_CLIENT Switch
show redundancy
2-373