Show Mac-Address-Table Static - Cisco 4500M Command Reference Manual

show mac-address-table static

show mac-address-table static
To display static MAC address table entries only, use the show mac-address-table static command.
Syntax Description
address mac_addr
interface type slot/port
protocol protocol
vlan vlan_id
Defaults
This command has no default settings.
Command Modes
Privileged EXEC
Command History Release
12.1(8a)EW
12.1(12c)EW
Usage Guidelines
For MAC address table entries used by routed ports, the routed port name is displayed in the "vlan"
column rather than the internal VLAN number.
The keyword definitions for the protocol argument are as follows:
•
•
•
•
Examples
This example shows how to display all static MAC address entries:
Switch# show mac-address-table static
Unicast Entries
vlan
-------+---------------+--------+---------------------+--------------------
1
Fa6/1
Fa6/2
Catalyst4500 Series SwitchCiscoIOS Command Reference—Release 12.2(18)EW
2-348
show mac-address-table static [address mac_addr | interface type number | protocol protocol |
vlan vlan_id]
(Optional) Specifies a 48-bit MAC address to match; the valid format is
H.H.H.
(Optional) Specifies an interface to match; valid values for type are
FastEthernet and GigabitEthernet.
(Optional) Specifies a protocol. See "Usage Guidelines" for more
information.
(Optional) Displays entries for a specific VLAN; valid values are from 1 to
4094.
Modification
Support for this command was introduced on the Catalyst 4500 series switch.
Added support for extended VLAN addresses.
assigned specifies assigned protocol entries.
ip specifies IP protocol.
ipx specifies IPX protocols.
other specifies other protocol entries.
mac address type
0030.94fc.0dff static ip,ipx,assigned,other
0030.94fc.0dff static ip,ipx,assigned,other
0030.94fc.0dff static ip,ipx,assigned,other
Chapter2 Cisco IOS Commands for the Catalyst 4500 Series Switches
protocols
Switch
Switch
Switch
port
78-16201-01