Power Inline - Cisco 4500M Command Reference Manual

Chapter2 Cisco IOS Commands for the Catalyst 4500 Series Switches

power inline

To set the inline-power state for the inline-power-capable interfaces, use the power inline command. To
return to the default values, use the no form of this command.
Syntax Description
auto
max milliwatt
never
static
consumption milliwatt
Defaults
The default settings are as follows:
•
•
•
Command Modes
Interface configuration
Command History Release
12.1(11)EW
12.1(19)EW
12.1(20)EW
Usage Guidelines
If your interface is not capable of supporting Power over Ethernet, you will receive this message:
Power over Ethernet not supported on interface Admin
78-16201-01
power inline {auto [max milliwatt] | never | static [max milliwatt] | consumption milliwatt}
no power inline
Sets the Power over Ethernet state to auto mode for inline-power-capable
interfaces.
(Optional) Maximum power that the equipment can consume; valid range is
from 2000 to 15400 mW.
Disables both the detection and power for the inline-power capable
interfaces.
Allocates power statically.
Sets power allocation per interface ; valid range is from 4000 to 15400. Any
non-default value disables automatic adjustment of power allocation.
Auto mode for Power over Ethernet is set.
Maximum milliwatt mode is set to 15400.
Default allocation is set to 15400.
Modification
Support for this command was introduced on the Catalyst 4500 series switch.
Support added for static power allocation.
Support added for Power over Ethernet.
Catalyst4500 Series SwitchCiscoIOS Command Reference—Release 12.2(18)EW
power inline
2-197