Macro Apply Cisco-Desktop - Cisco 4500M Command Reference Manual

macro apply cisco-desktop

macro apply cisco-desktop
To enable Cisco-recommended features and settings that are suitable for connecting a switch port to a
standard desktop, use the macro apply cisco-desktop command.
Syntax Description
$AVID access_vlanid
Defaults
This command has no default settings.
Command Modes
Interface configuration
Command History Release
12.2(18)EW
Usage Guidelines
This command can only be viewed and applied; it cannot be modified.
Ensure that the existing configuration on the interface does not conflict with the intended macro
configuration. Before you apply the macro, clear the configuration on the interface with the default
interface command.
Examples
This example shows how to enable the Cisco-recommended features and settings on port fa2/1:
Switch(config)# interface FastEthernet2/1
Switch(config-if)# macro apply cisco-desktop $AVID 50
Switch(config-if)#
This contents of this macro are as follows:
# Basic interface - Enable data VLAN only
# Recommended value for access vlan (AVID) should not be 1
switchport access vlan $AVID [access_vlanid]
switchport mode access
# Enable port security limiting port to a single
# MAC address -- that of desktop
switchport port-security
# Ensure port-security age is greater than one minute
# and use inactivity timer
# "Port-security maximum 1" is the default and will not
# Show up in the config
switchport port-security violation restrict
switchport port-security aging time 2
switchport port-security aging type inactivity
# Configure port as an edge network port
spanning-tree portfast
spanning-tree bpduguard enable
Catalyst4500 Series SwitchCiscoIOS Command Reference—Release 12.2(18)EW
2-172
macro apply cisco-desktop $AVID access_vlanid
Specifies an access VLAN ID.
Modification
Support for this command was introduced on the Catalyst 4500 series switch.
Chapter2 Cisco IOS Commands for the Catalyst 4500 Series Switches
78-16201-01