Cisco 4500M Command Reference Manual page 130

errdisable recovery
Defaults
Error disable recovery is disabled.
The recovery interval is set to 300 seconds.
Command Modes
Configuration
Command History Release
12.1(8a)EW
12.1(19)EW
Usage Guidelines
A cause (bpduguard, dtp-flap, link-flap, pagp-flap, udld) is defined as the reason the error-disabled state
occurred. When a cause is detected on an interface, the interface is placed in error-disabled state (an
operational state similar to link-down state). If you do not enable error-disable recovery for the cause,
the interface stays in error-disabled state until a shutdown and no shutdown occurs. If you enable
recovery for a cause, the interface is brought out of error-disabled state and allowed to retry operation
again once all the causes have timed out.
You must enter the shutdown command and then the no shutdown command to recover an interface
manually from error disable.
Examples
This example shows how to enable the recovery timer for the BPDU guard error disable cause:
Switch(config)# errdisable recovery cause bpduguard
Switch(config)#
This example shows how to set the timer to 300 seconds:
Switch(config)# errdisable recovery interval 300
Switch(config)#
To enable errdisable recovery for arp-inspection, do the following:
Switch(config)# errdisable recovery cause arp-inspection
Switch(config)# end
Switch# show errdisable recovery
ErrDisable Reason
-----------------
udld
bpduguard
security-violatio
channel-misconfig
vmps
pagp-flap
dtp-flap
link-flap
l2ptguard
psecure-violation
gbic-invalid
dhcp-rate-limit
unicast-flood
storm-control
arp-inspection
Catalyst4500 Series SwitchCiscoIOS Command Reference—Release 12.2(18)EW
2-98
Modification
Support for this command was introduced on the Catalyst 4500 series switch.
Support for the storm-control feature.
Timer Status
--------------
Disabled
Disabled
Disabled
Disabled
Disabled
Disabled
Disabled
Disabled
Disabled
Disabled
Disabled
Disabled
Disabled
Disabled
Enabled
Chapter2 Cisco IOS Commands for the Catalyst 4500 Series Switches
78-16201-01