Show Ip Igmp Snooping Mrouter - Cisco 4500M Command Reference Manual

show ip igmp snooping mrouter

show ip igmp snooping mrouter
To display information on dynamically learned and manually configured multicast switch interfaces, use
the show ip igmp snooping mrouter command.
Syntax Description
vlan vlan-id
Defaults
This command has no default settings.
Command Modes
Privileged EXEC
Command History Release
12.1(8a)EW
12.1(19)EW
Usage Guidelines
You can also use the
address table for a VLAN that has IGMP snooping enabled.
You can display IGMP snooping information for VLAN interfaces by entering the show ip igmp
interface vlan vlan-num command.
Examples
This example shows how to display snooping information for a specific VLAN:
Switch# show ip igmp snooping mrouter vlan 1
vlan
-----+----------------------------------------
1
Switch#
Related Commands
ip igmp snooping vlan mrouter
show ip igmp interface
show mac-address-table multicast
Catalyst4500 Series SwitchCiscoIOS Command Reference—Release 12.2(18)EW
2-314
show ip igmp snooping mrouter [{vlan vlan-id}]
(Optional) Specifies a VLAN; valid values are from 1 to 1001 and from 1006 to 4094.
Modification
Support for this command was introduced on the Catalyst 4500 series switch.
Added support for extended VLAN addresses.
show mac-address-table multicast
ports
Gi1/1,Gi2/1,Fa3/48,Switch
Chapter2 Cisco IOS Commands for the Catalyst 4500 Series Switches
command to display entries in the MAC
78-16201-01