Macro Apply Cisco-Phone - Cisco 4500M Command Reference Manual

macro apply cisco-phone

macro apply cisco-phone
To enable Cisco-recommended features and settings that are suitable for connecting a switch port to a
standard desktop and a Cisco IP phone, use the macro apply cisco-phone command.
Syntax Description
$AVID access_vlanid
$VVID voice_vlanid
Defaults
This command has no default settings.
Command Modes
Interface configuration
Command History Release
12.2(18)EW
Usage Guidelines
This command can only be viewed and applied; it cannot be modified.
Ensure that the existing configuration on the interface does not conflict with the intended macro
configuration. Before you apply the macro, clear the configuration on the interface with the default
interface command.
Examples
This example shows how to enable the Cisco-recommended features and settings on port fa2/1:
Switch(config)# interface FastEthernet2/1
Switch(config-if)# macro apply cisco-phone $AVID 10 $VVID 50
Switch(config-if)#
This contents of this macro are as follows:
# VoIP enabled interface - Enable data VLAN
# and voice VLAN (VVID)
# Recommended value for access vlan (AVID) should not be 1\
switchport access vlan $AVID [access_vlan_id]
switchport mode access
# Update the Voice VLAN (VVID) value which should be
# different from data VLAN
# Recommended value for voice vlan (VVID) should not be 1
switchport voice vlan $VVID [voice_vlan_id]
# Enable port security limiting port to a 3 MAC
# addressees -- One for desktop and two for phone
switchport port-security
switchport port-security maximum 3
# Ensure port-security age is greater than one minute
# and use inactivity timer
Catalyst4500 Series SwitchCiscoIOS Command Reference—Release 12.2(18)EW
2-174
macro apply cisco-phone $AVID access_vlanid $VVID voice_vlanid
Specifies an access VLAN ID.
Specifies a voice VLAN ID.
Modification
Support for this command was introduced on the Catalyst 4500 series switch.
Chapter2 Cisco IOS Commands for the Catalyst 4500 Series Switches
78-16201-01