Power Dc Input - Cisco 4500M Command Reference Manual

power dc input

power dc input
To configure power DC input parameters on the switch, use the power dc input command. To return to
the default power settings, use the no form of this command.
Syntax Description
dc input
watts
Defaults
DC power input is 2500 watts.
Command Modes
Global configuration
Command History Release
12.1(11)EW
12.1(13)EW
Usage Guidelines
If your interface is not capable of supporting Power over Ethernet, you will receive the following error
message:
Power over Ethernet not supported on interface Admin
Examples
This example shows how to set the total capacity of the external DC power source to 5000 watts:
Switch(config)# power dc input 5000
Switch(config)#
Related Commands
show power
Catalyst4500 Series SwitchCiscoIOS Command Reference—Release 12.2(18)EW
2-196
power dc input watts
no power dc input
Specifies the external DC source for both power supply slots.
Sets the total capacity of the external DC source in watts; valid values are from
300 to 8500.
Modification
Support for this command was introduced on the Catalyst 4500 series switch.
Support for dc input was added.
Chapter2 Cisco IOS Commands for the Catalyst 4500 Series Switches
78-16201-01