Vlan Access-Map - Cisco 4500M Command Reference Manual

vlan access-map

vlan access-map
To enter the VLAN access-map command mode to create a VLAN access map, use the vlan access-map
command. To remove a mapping sequence or the entire map, use the no form of this command.
Syntax Description
name
seq#
Defaults
This command has no default settings.
Command Modes
Global configuration
Command History Release
12.1(12c)EW
Usage Guidelines
If you enter the sequence number of an existing map sequence, you enter VLAN access-map mode. If
you do not specify a sequence number, a number is automatically assigned. You can enter one match
clause and one action clause per map sequence. If you enter the no vlan access-map name [seq# ]
command without entering a sequence number, the whole map is removed. Once you enter VLAN
access-map mode, the following commands are available:
•
•
•
•
•
•
Examples
This example shows how to enter the VLAN access-map mode:
Switch(config)# vlan access-map cisco
Switch(config-access-map)#
Related Commands
match
show vlan access-map
Catalyst4500 Series SwitchCiscoIOS Command Reference—Release 12.2(18)EW
2-498
vlan access-map name [seq# ]
no vlan access-map name [seq# ]
VLAN access-map tag.
(Optional) Map sequence number; valid values are from 0 to 65535.
Modification
Support for this command was introduced on the Catalyst 4500 series switch.
action—Sets the action to be taken (forward or drop).
default—Returns a command to its default settings.
end—Exits from configuration mode.
exit—Exits from VLAN access-map configuration mode.
match—Sets the values to match (IP address or MAC address).
no—Negates a command or reset its defaults.
Chapter2 Cisco IOS Commands for the Catalyst 4500 Series Switches
78-16201-01