Ip Igmp Profile - Cisco 4500M Command Reference Manual
Command reference
Hide thumbs
Also See for 4500M:
- Software manual (608 pages) ,
- Hardware installation and maintenance manual (143 pages) ,
- Upgrade manual (24 pages)
Table of Contents
Advertisement
Chapter2
Cisco IOS Commands for the Catalyst 4500 Series Switches
ip igmp profile
To create an IGMP profile, use the ip igmp profile command. To delete the IGMP profile, use the no
form of this command.
Syntax Description
profile number
Defaults
No profile created.
Command Modes
Global configuration
IGMP profile configuration
Command History
Release
12.1(11b)EW
Usage Guidelines
When entering a range, enter the low IP multicast address, a space, and the high IP multicast address.
You can apply an IGMP profile to one or more Layer 2 interfaces, but each interface can have only one
profile applied to it.
Examples
This example shows how to configure IGMP profile 40 that permits the specified range of IP multicast
addresses.
Switch # config terminal
Switch(config)# ip igmp profile 40
Switch(config-igmp-profile)# permit
Switch(config-igmp-profile)# range 233.1.1.1 233.255.255.255
Switch(config-igmp-profile)#
Related Commands
ip igmp filter
show ip igmp profile
78-16201-01
ip igmp profile profile number
no ip igmp profile profile number
IGMP profile number being configured; valid values are from 1 to 4294967295.
Modification
Support for this command was introduced on the Catalyst 4500 series switch.
Catalyst4500 Series SwitchCiscoIOS Command Reference—Release 12.2(18)EW
ip igmp profile
2-135
Advertisement
Table of Contents
