Qos Aggregate-Policer - Cisco 4500M Command Reference Manual

qos aggregate-policer

qos aggregate-policer
To define a named aggregate policer, use the qos aggregate-policer command. To delete a named
aggregate policer, use the no form of this command.
Syntax Description
name
rate
burst
conform-action
transmit
drop
exceed-action
policed-dscp-transmit
Defaults
The default settings are as follows:
•
•
Command Modes
Global configuration
Command History Release
12.1(8a)EW
Usage Guidelines
This policer can be shared by different policy map classes and on different interfaces.
The Catalyst 4006 switch supports up to 1000 aggregate input policers and 1000 output policers.
The qos aggregate-policer command allows you to configure an aggregate flow and a policing rule for
that aggregate. When you enter your rate and burst parameters, the range for the average rate is 32 Kbps
to 32 Gbps, and the range for the burst size is 1 KB to 512 MB.
A rate can be entered in bits-per-second without a suffix. In addition, the suffixes described in
Table2-10
Catalyst4500 Series SwitchCiscoIOS Command Reference—Release 12.2(18)EW
2-212
qos aggregate-policer name rate burst [conform-action {transmit | drop} |
exceed-action {transmit | drop | policed-dscp-transmit}]
no qos aggregate-policer name
Name of the aggregate policer.
Maximum bits per second; valid values are from 32000 to 32000000000.
Burst bytes; valid values are from 1000 to 512000000.
(Optional) Specifies the action to be taken when the rate is not exceeded.
(Optional) Transmits the package.
(Optional) Drops the packet.
(Optional) Specifies action when QoS values are exceeded.
(Optional) Sends the DSCP per the policed-DSCP map.
Conform-action transmits
Exceed-action drops
Modification
Support for this command was introduced on the Catalyst 4500 series switch.
are allowed.
Chapter2 Cisco IOS Commands for the Catalyst 4500 Series Switches
78-16201-01