Policy-Map - Cisco 4500M Command Reference Manual

policy-map

policy-map
To access the QoS policy map configuration mode to configure the QoS policy map, use the policy-map
command. To delete a policy map, use the no form of this command.
Syntax Description
policy-map-name
Defaults
This command has no default settings.
Command Modes
Global configuration
Command History Release
12.1(8a)EW
Usage Guidelines
In QoS policy-map configuration mode, these configuration commands are available:
•
•
•
•
•
Examples
This example shows how to create a policy map named ipp5-policy that uses the class-map named ipp5
and is configured to rewrite the packet precedence to 6 and to aggregate police the traffic that matches
IP precedence value of 5:
Switch# config terminal
Enter configuration commands, one per line. End with CNTL/Z.
Switch(config)# policy-map ipp5-policy
Switch(config-pmap)# class ipp5
Switch(config-pmap-c)# set ip precedence 6
Switch(config-pmap-c)# police 2000000000 2000000 conform-action transmit exceed-action
policed-dscp-transmit
Switch(config-pmap-c)# end
Catalyst4500 Series SwitchCiscoIOS Command Reference—Release 12.2(18)EW
2-192
policy-map policy-map-name
no policy-map policy-map-name
Specifies the name of the policy map.
Modification
Support for this command was introduced on the Catalyst 4500 series switch.
exit exits QoS class map configuration mode.
no removes an existing defined policy map.
class class-map-name accesses the QoS class map configuration mode to specify a previously
created class map to be included in the policy map or to create a class map. (See the
command for additional information.)
police [aggregate name] rate burst [conform-action {drop | transmit}] [{exceed-action {drop |
policed-dscp-transmit | transmit}] defines a microflow or aggregate policer.
trust {cos | dscp} sets the specified class trust values. Trust values that are set in this command
supersede trust values set on specific interfaces.
Chapter2 Cisco IOS Commands for the Catalyst 4500 Series Switches
class-map
78-16201-01