Vlan Filter - Cisco Catalyst 4500 Series Configuration Manual

vlan filter

vlan filter
To apply a VLAN access map, use the vlan filter command. To clear the VLAN access maps from
VLANs or interfaces, use the no form of this command.
Syntax Description
map-name
vlan-list vlan-list
Command Default This command has no default settings.
Command Modes
Global configuration mode
Command History Release
12.1(12c)EW
Usage Guidelines When configuring an action clause in a VLAN access map, note the following:
•
•
•
When entering the no form of this command, the vlan-list parameter is optional (but the keyword
vlan-list is required). If you do not enter the vlan-list parameter, the VACL is removed from all the
VLANs where the map-name is applied.
Examples The following example shows how to apply a VLAN access map on VLANs 7 through 9:
Switch(config)# vlan filter ganymede vlan-list 7-9
Switch(config)#
Catalyst 4500 Series Switch Cisco IOS Command Reference—Release XE 3.9.xE and 15.2(5)Ex
2-1172
vlan filter map-name {vlan-list vlan-list}
no vlan filter map-name {vlan-list [vlan-list]}
VLAN access-map tag.
Specifies the VLAN list; see the "Usage Guidelines" section for valid values.
Modification
This command was introduced on the Catalyst 4500 series switch.
You can apply the VLAN access map to one or more VLANs.
The vlan-list parameter can be a single VLAN ID, a list of VLAN IDs, or VLAN ID ranges
(vlan-id-vlan-id). Multiple entries are separated by (-), (hyphen), or (,) (comma).
You can apply only one VLAN access map to each VLAN.
Chapter 2