Switchport Private-Vlan Host-Association - Cisco 4500M Command Reference Manual

Chapter2 Cisco IOS Commands for the Catalyst 4500 Series Switches

switchport private-vlan host-association

To define a PVLAN association for an isolated or community port, use the switchport private-vlan
host-association command. To remove the PVLAN mapping from the port, use the no form of the
command.
Syntax Description
primary-vlan-id
secondary-vlan-list
Defaults
Private VLAN mapping is disabled.
Command Modes
Interface configuration
Command History Release
12.1(8a)EW
12.1(12c)EW
Usage Guidelines
There is no runtime effect on the port unless it is in PVLAN host mode. If the port is in PVLAN host
mode but neither of the VLANs exists, the command is allowed, but the port is made inactive.
The secondary VLAN may be an isolated or community VLAN.
Examples
This example shows how to configure a port with a primary VLAN (VLAN 18) and secondary VLAN
(VLAN 20):
Switch(config-if)# switchport private-vlan host-association 18 20
Switch(config-if)#
This example shows how to remove the PVLAN association from the port:
Switch(config-if)# no switchport private-vlan host-association
Switch(config-if)#
Related Commands
show interfaces switchport
switchport mode
78-16201-01
switchport private-vlan host-association {primary-vlan-id} {secondary-vlan-id}
no switchport private-vlan host-association
Number of the primary VLAN of the PVLAN relationship; valid values are from
1 to 4094.
Number of the secondary VLAN of the private VLAN relationship; valid values
are from 1 to 4094.
Modification
Support for this command was introduced on the Catalyst 4500 series switch.
Support for extended addressing was added.
Catalyst4500 Series SwitchCiscoIOS Command Reference—Release 12.2(18)EW
switchport private-vlan host-association
2-469