Cisco 4500M Command Reference Manual page 215

Chapter2 Cisco IOS Commands for the Catalyst 4500 Series Switches
queue queue_id
,
-
both
r x
tx
filter
vlan vlan_id
packet-type
good
bad
address-type unicast | multicast |
broadcast
Defaults
Received and transmitted traffic , as well as all VLANs, packet types , and address types are monitored
on a trunking interface.
Packets are transmitted untagged out the destination port; ingress and learning are disabled.
Command Modes
Global configuration
Command History Release
12.1(8a)EW
12.1(11b)EW
12.1(19)EW
12.1(20)EW
78-16201-01
Specifies that only traffic received on the specific CPU
subqueue should be copied to the destination of the session.
Valid values are from 1 to 32, or by the following names: all,
control-packet, rpf-failure, adj-same-if, nfl, mtu-exceeded,
unknown-sa, span, acl input, acl input log, acl input error, acl
input forward, acl input punt, acl output, acl output log, acl
output error, acl output forward, acl output punt, bridged,
bridged 1, bridged 2, bridged 3, bridged 4, routed received,
routed received 1, routed received 2, routed received 3, routed
received 4, routed forward, routed forward 1, routed forward 2,
routed forward 3, and routed forward 4.
(Optional) Symbol to specify another range of SPAN VLANs;
valid values are from 1 to 4094.
(Optional) Symbol to specify a range of SPAN VLANs.
(Optional) Monitors and filters received and transmitted traffic.
(Optional) Monitors and filters received traffic only.
(Optional) Monitors and filters transmitted traffic only.
Limits SPAN source traffic to specific VLANs.
(Optional) Specifies the VLAN to be filtered. The number is
entered as a single value or a range; valid values are from 1to
4094.
Limits SPAN source traffic to packets of a specified type.
Specifies a good packet type
Specifies a bad packet type.
Limits SPAN source traffic to packets of a specified address
type. Valid types are unicast, multicast , and broadcast.
Modification
Support for this command was introduced on the Catalyst 4500 series switch.
Support for differing directions within a single-user session and extended VLAN
addressing was added.
Support for ingress packets, encapsulation specification, packet and address type
filtering, and CPU source sniffing enhancements.
Support for remote SPAN and host learning on ingress-enabled destination ports
was added.
Catalyst4500 Series SwitchCiscoIOS Command Reference—Release 12.2(18)EW
monitor session
2-183