Chapter2
Cisco IOS Commands for the Catalyst 4500 Series Switches
Enter the
To turn off suppression for the specified traffic type, you can do one of the following:
•
•
Lower level is ignored for interfaces that perform storm control in hardware.
Examples
This example shows how to enable broadcast storm control on a port with a 75.67 percent rising
suppression level:
Switch(config-if)# storm-control broadcast level 75.67
This example shows how to disable the port during a storm:
Switch(config-if)# storm-control action shutdown
This example shows how to disable storm control on a port:
Switch(config-if)# no storm-control broadcast level
This example shows how to disable storm control by setting high l evel to 200 percent:
Switch(config-if)# storm-control broadcast level 200
Related Commands
show interfaces counters
show running-config
78-16201-01
show running-config
Set the high-level value to 100 percent for the specified traffic type.
Use the no form of this command.
Catalyst4500 Series SwitchCiscoIOS Command Reference—Release 12.2(18)EW
command to display the enabled suppression mode and level setting.
storm-control
2-455