GE LOGIQ E9 Service Manual page 660

Hide thumbs Also See for LOGIQ E9:

Table of Contents

5535208-100, R

Mount the transmitter and tighten the

transmitter mounting screws (A) on the arm

and route the cable through the cable

management channels (B), in the under-

side of the arms. The arm is showed in the

stowed position.

While supporting the arm (loaded with the

transmitter), slowly loosen the knob which

allows the arm to gradually move down the

NOTE: The arm must move down the

channel very slowly when the knob is

loosened, and it must move easily upward

when lifting. If the arm free-falls or will not

move, follow the adjustment procedure,

Mechanism" on page

Adjusting Tension on Sliding Mechanism

Remove the plastic bolt cap from the lower

tension nut.

The clamping knob must be unlocked while

making this adjustment. Using the 1/2 inch

socket wrench, loosen or tighten the

tension nut for the desired tension.

Perform Functional Checks. See:

8-12-6-2 - Verification

Section 8-12 - V Nav Roll Stand and/or On-Board Stand Installation and/or Replacement

Table 8-193 Option Installation to LOGIQ E9

8-12-6 "Adjusting Tension on Sliding

Table 8-194 Adjusting Tension on Sliding Mechanism

8-12-6-3 "Functional Checks" on page

Corresponding Graphic

Plastic Bolt Cap for tension nut and Unlocking

8-12-6-1 - Calibration and

Clamping Knob

adjustments,