GE LOGIQ E9 Service Manual page 430

GE
D 5535208-100, R
IRECTION
8-5-21 Bulkhead Cover replacement
8-5-21-1 Manpower
One person, 15 minutes.
8-5-21-2 Tools
No tools are needed to replace the Bulkhead Cover.
8-5-21-3 Preparations
When preparing for the replacement, you must perform the following steps:
1.) Power down the system.
2.) Disconnect the mains power cable from the wall outlet.
3.) Disconnect all Probes and External I/O Cabling.
Follow this link if you need more information:
4-2-3 "Power shut down" on page 4-7.
8-5-21-4 Bulkhead Cover removal
1.) At the rear of the system, release the console's frogleg mechanism by inserting a screwdriver into
the release point and pressing until release. Pull the console out to its extended position to gain
access to the screws in the next step.
8 - 84
. 2
EV
Figure 8-38 XY / Frogleg mechanism release
Section 8-5 - Replacing Covers and Bumpers
LOGIQ E9 S M
ERVICE ANUAL