GE LOGIQ E9 Service Manual page 465

GE
D 5535208-100, R
IRECTION
8-6-4-1 V2 LCD Arm Assembly Adapter removal
Table 8-74
1.
Remove the Bulkhead Cover.
2.
Disconnect the LCD cables; video (P10)
and power (P3) from the LCD.
The Video Cable has a retainer and screw.
Loosen the screw with a small, flat blade
screwdriver.
3.
Remove the Ground Cable from the LCD
Adapter and the Bulkhead. Discard (the
new FRU will includes the cable and
mounting hardware).
2.
Remove the Plate. The plate is captured by
the two retaining pins that protrude from the
Adapter.
NOTE: A pin or pick can be used to lift the
plate slightly to remove.
. 2
EV
V2 LCD Arm Assembly Adapter removal
Steps
Chapter 8 Replacement procedures
LOGIQ E9 S
Corresponding Graphic
LCD Ground Cable installed
M
ERVICE ANUAL
8 - 119