GE LOGIQ E9 Service Manual page 561

Hide thumbs Also See for LOGIQ E9:

Table of Contents

5535208-100, R

Table 8-127 BEP installation

NOTE: If you DO NOT reconnect the internal BEP cable to the Backplane, the system will power

up but WILL NOT scan or WILL LAUNCH into simulator mode.

Insert the bottom lip of the BEP cover inside the base of the BEP.

Connect the battery cable to PCN1 and the CB to PB cable to PCN2 on the CB. Make sure the

cable connectors are "locked" into place on the CB connections.

MAKE SURE all cables are clear of the BEP Cover and tilt the top of the BEP cover toward the

Be careful not to pinch any of the cables when installing the BEP cover.

10. Tighten and secure the thumb screws or screws at the top of the BEP cover, or the three screws

that attach the cover to the BEP.

11. Replace the Printer Tray at the top of the BEP.

Be sure the lip, on the underside of the bracket, hooks on the edge of the card rack, and the three

tabs insert into the slots on the top of the BEP frame. The lip "clamps" the card rack and BEP

together. This is a tight fit.

12. Lower the lower Column Cover. Make sure the Column Cover is behind the Printer Tray.

13. Position the Front Cover to engage the Column Cover stop tabs.

14. Latch the two latches that clamp the Printer Tray to the top of the BEP.

15. Slide the Black and White printer into the

Printer Tray and connect the cables to the

back of the printer. Or, reinstall the Shear

Wave Capacitor Pack, if present. See:

8-11-9 "Shear Wave Capacitor Pack

replacement" on page

16. Tighten the Printer Tray wing nut to secure the printer.

17. Connect all cables at the top of the BEP and all I/O cables.

18. Replace the covers.

19. Reinstall Base Load and Application software.

20. Enter the system's TCPIP settings and Option strings.

21. Restore the Patient Archive images, Report Archive, User-Defined Configuration (Customer

Presets), and Service settings.

Chapter 8 Replacement procedures

Corresponding Graphic

Printer aligned with Printer Tray