GE LOGIQ E9 Service Manual page 552

Hide thumbs Also See for LOGIQ E9:

Table of Contents

5535208-100, R

Table 8-123 BEP installation - R3.x and earlier

10. Replace the Printer Tray at the top of the BEP.

Be sure the lip, on the underside of the bracket, hooks on the edge of the card rack, and the three

tabs insert into the slots on the top of the BEP frame. The lip "clamps" the card rack and BEP

together. This is a tight fit.

11. Lower the lower Column Cover. Make sure the Column Cover is behind the Printer Tray.

12. Position the Front Cover to engage the Column Cover stop tabs.

13. Latch the two latches that clamp the Printer Tray to the top of the BEP.

14. Slide the Black and White printer into the

Printer Tray and connect the cables to the

back of the printer.

15. Tighten the Printer Tray wing nut to secure the printer.

16. Connect all cables at the top of the BEP and all I/O cables.

17. Replace the covers.

18. Reinstall Base Load and Application software.

19. Enter the system's TCPIP settings and Option strings.

20. Restore the Patient Archive images, Report Archive, User-Defined Configuration (Customer

Presets), and Service settings.

21. Perform Functional Checks. See:

8-9-3-5 "Functional Checks" on page

Section 8-9 - BEP (Back End Processor) parts replacement

Corresponding Graphic

8-9-3-3 - Calibration and

adjustments,

8-9-3-4 - Verification