GE LOGIQ E9 Service Manual page 417

GE
D 5535208-100, R
IRECTION
8-5-17 Printer Filler Storage
8-5-17-1 Manpower
One person, 15 minutes.
8-5-17-2 Tools
For tools needed, refer to:
8-5-17-3 Preparations
When preparing for the replacement, you must perform the following steps:
1.) Power down the system.
2.) Disconnect the mains power cable from the wall outlet.
3.) Disconnect all Probes and External I/O Cabling.
4.) Remove the Right Side cover.
Follow these links if you need more information:
• 4-2-3 "Power shut down" on page 4-7.
• 8-5-2 "Side Covers replacement" on page 8-30.
8-5-17-4 Printer Filler Storage
1.) Release the fixing bracket.
2.) Pull the Printer Filler Storage forwards, out of the system.
8-5-17-5 Printer Filler Storage installation
NOTE: The Printer Filler Storage is used in the printer compartment on systems without an on-board
printer.
1.) Insert the Printer Filler Storage from the front of the system, into the empty printer compartment.
2.) Fasten (lock) the fixing bracket.
3.) Install the Side Cover you removed earlier.
. 2
EV
8-2-5 "Tools needed for servicing the LOGIQ E9" on page
Chapter 8 Replacement procedures
LOGIQ E9 S M
ERVICE ANUAL
8-5.
8 - 71