GE LOGIQ E9 Service Manual page 542

GE
D 5535208-100, R
IRECTION
8-8-3-4 Front Casters removal
1.) Turn Front Casters so they are pointing forwards.
2.) Activate Direction Lock.
3.) Put the Bevel Edged Board on the floor.
Prior to elevating scanner, verify that the floating Operator Panel is locked in its lowest,
WARNING WARNING
parking position.
Use extreme caution as long as LOGIQ E9 is un-stable, not resting on all four Casters.
WARNING WARNING
4.) Pull the system backwards up the board incline. This will lift the Rear Wheel on the opposite side of
the System from the floor.
5.) Turn the Rear Caster that stands on the Bevel Edged Board in the direction as shown in
Figure
6.) The system is now nearly balanced between one Front and one Rear Caster.
7.) Make the LOGIQ E9 rest on both Rear Casters and lift the Front Caster.
8.) Put the Wooden Wedge under the chassis. This will stabilize the LOGIQ E9 with one Front Caster
free from the floor.
9.) Unscrew and remove the fixing screws (T-45) for the Front Caster that is free from the floor. Save
the screw for later use.
10.)Remove the Caster.
11.)Disconnect the lock by unscrewing the hex nut that holds it to the rod.
8 - 196
. 2
EV
8-65.
Figure 8-66 Pull system backwards up the board incline
Section 8-8 - Casters and Brakes replacement
LOGIQ E9 S M
ERVICE ANUAL