GE LOGIQ E9 Service Manual page 471

Hide thumbs Also See for LOGIQ E9:

Table of Contents

5535208-100, R

It is not necessary to remove the LCD Monitor or the LCD Arm.

Remove the rear cover of LCD monitor.

For easy access, tilt the LCD Monitor forward to horizontal position.

NOTE: You CANNOT fully remove the cover unless the LCD is tilted forward to the horizontal

To remove the dongle, slightly lift up the end to disengage the Velcro, then pull the dongle out of

the USB port.

WLAN installation

NETGEAR USB dongle WN111 is

identified with the following markings:

Remove the dongle from the Factory

Remove the plastic cover from the dongle

and discard.

Remove the Velcro pieces from the Factory

Discard all other items included in the

dongle packaging, only the dongle and

Velcro are required.

Choose a piece of Velcro with the Hook

"gender" (rigid piece). Remove the

adhesive protection strip and attach this

portion of the Velcro to the dongle on the

side WITHOUT the LED, at the orientation

and location as shown.

The outer edges of the Velcro have no

hooks. Attach the Velcro at this orientation,

to prevent covering up the vent holes. DO

NOT cover the vent holes.

Align the Velcro where the flat starts to

WLAN removal

WLAN installation

Chapter 8 Replacement procedures

Corresponding Graphic