Preventative Maintenance Visual/Functional Checks; Procedural Lists - GE T2100-ST1 Service Manual

Functional / Post Repair / Preventative Maintenance Checkout Procedures

Preventative Maintenance Visual/Functional Checks

10.
a. Check the device case for cracks or any other
b. Check plugs, cords, cable insulation jacket, and
c.
d. Press the Emergency STOP Button (ESB) and the
e. Pull the safety tether system (STS) the treadmill will
f.
g. Check running belt tension and correct as required.
h. Observe running belt tracking and correct as
i.
j.

Procedural Lists

The following tables identify the tools, checkout procedures, and
safety electrical checks required after completing each repair or
preventative maintenance procedure. To use these tables, find
the applicable procedure in the first column, then locate the
Tools, Functional Checkout Procedures, and Electrical Safety
Checks associated with that procedure. Use the numbers in
those columns to locate the corresponding details earlier in this
chapter.
For a list of the tools, refer to "Tools Required" on page 181.
For the checkout procedure details, refer to "Checkout
Procedures" on page 181.
For the electrical safety check details, refer to "Electrical Safety
Checks" on page 184.
2097937-002 Rev G
11 March 2019
Perform the following inspections for visual signs of
excess wear or damage.
visual damage.
connectors for bent prongs or pins.
Check handles for wear and or damage.
treadmill will coast to a stop. To release the
emergency stop switch, turn the push button ¼-
turn in counter clockwise direction. The treadmill
will return to 0.0% elevation.
have a controlled stop. To re-attach the pull tether,
attach clip to the original position on the switch.
The treadmill will return to 0.0% elevation.
Evaluate the condition of the deck and running
belt.
required.
Check the drive belt tension and correct as
required.
Clean and lubricate the treadmill elevation screw.
If the treadmill hood has been opened, check that
the interior is free of excessive dust build-up, if
necessary; use commercially available compressed
air to clean following manufacturer's instructions.
Expected Results: No visual damage, no wear
detected, maintenance checks / procedures
performed successfully.
T2100-ST1 Treadmill, 110V / T2100-ST2 Treadmill, 220V
Pass/Fail
185