GE T2100-ST1 Service Manual page 136

Component/FRU Removal and Replacement
Rear Roller
See Note 3
Belt Tension Plate
Tension Bolt
See Note 1
End Cap Bolt
End Cap
136
33. Align the bolt holes on the rear roller with the access hole
of the end caps.
34. Start the tensioning bolts on the rear roller but do not
tighten.
35. Replace the left and right end caps and replace the
securing screws.
36. Adjust the tension of the running belt.
See "Running Belt Tension Adjustment" on page 60.
37. Reinstall the hood.
Flat Head
Allen Screw
T2100-ST1 Treadmill, 110V / T2100-ST2 Treadmill, 220V
Running Belt
Preset to .125 for
proper belt tracking.
Deck Rail
Support
Deck Rail Nut
NOTES:
1. ADJUSTMENT SCREWS MUST BE MATCH TIGHTENED. PROPER TENSTION
IS ACHIEVED WHEN BELT CAN'T SLIP ON PULLEYS WHEN IN OPERATON.
2. ADJUST DRIVE BELT TENTION PULLING ALL FREE PLAY OUT OF BELT. DO
NOT OVER TIGHTEN CAUSING THE BELT TO STRETCH.
3. MOVE REAR PULLEY SIDE TO SIDE IN CHANNELS TO OBTAIN FRONT TO
REAR BELT ALIGNMENT AND TRACKING.
Front Roller
See Note 2
Roller Bolt
Drive Belt
Running Deck
2097937-002 Rev G
11 March 2019