Replacing The Center Handrail - GE T2100-ST1 Service Manual

Replacing the Center Handrail

Tools Required
o
o
o
1.
2.
3.
4.
5.
6.
7.
2097937-002 Rev G
11 March 2019
1/8" Allen Wrench
5/32" Allen Wrench
Grounding Wrist Strap
Approximate time to complete: 30 min
Turn the treadmill's power switch to the OFF position.
Unplug the treadmill from the wall receptacle.
Allow the treadmill to discharge for 1 minute.
Remove the ESB or STS.
See "Replacing the Emergency Stop Button (ESB)" on page
148 or "Replacing the Stop Tether Switch (STS)" on page 150
for instructions.
CAUTION:
Use ESD precautions, including wearing a grounding
wrist strap that is connected to an exposed metal
connection point on the treadmill chassis.
With the 5/32" Allen Wrench, remove the eight ¼"-20
screws holding the center handrail to the handrail
assembly.
Feed wire harness through center handrail.
Pay close attention when removing as to not damage the
wires running through the center handrail assembly.
The center handrail is ready to be replaced.
Reverse steps 1 through step 6 to install replacement
center handrail.
ESB or STS Assembly
T2100-ST1 Treadmill, 110V / T2100-ST2 Treadmill, 220V
Component/FRU Removal and Replacement
4 ¼"-20 Screws
Wire Harness
153