Secure Cables; Running Belt Tracking Adjustment; Running Belt Tension Adjustment - GE T2100-ST1 Service Manual

Assembly and Setup

Secure Cables

Tie down cables to ensure they do not get caught in the wheels
or the elevation racks.

Running Belt Tracking Adjustment

NOTE:
The patented MasterTrack
reduces the need to adjust the belt on your T2100-ST1 or T2100-
ST2 treadmill. However, when you operate your treadmill for the
first time, you may need to adjust the tracking of the belt to
conform to your floor. You may also need to adjust the tracking if
you move the machine to another location. (See "Running Belt
Tracking Adjustment" on page 59 for details.)

Running Belt Tension Adjustment

Your running belt has been pre-tensioned at the factory and run
for 16 hours prior to shipment. It may, however, be necessary to
adjust the belt tension when the treadmill is run in its final
location. A loose belt tends to hesitate or stick with a heavy foot
plant. If your belt needs tensioning, the adjustment procedure
can be found in "Running Belt Tension Adjustment" on page 60.
NOTE:
42
This adjustment is not covered under your warranty after
installation. It is important that you review these
instructions thoroughly before proceeding with belt
tracking adjustment. Uneven floors accelerate belt
misalignment. This situation may require more frequent
adjustment to prevent belt damage.
Improper adjustment could cause the treadmill to hesitate
and cause a trip and fall hazard. This adjustment is not
covered under your warranty after installation. It is
important that you review these instructions thoroughly
before proceeding.
T2100-ST1 Treadmill, 110V / T2100-ST2 Treadmill, 220V
Belt Tracking System significantly
®
2097937-002 Rev G
11 March 2019