Weekly Maintenance; Monthly Maintenance; Semiannual Maintenance; Belt Cleaning And Inspection - GE T2100-ST1 Service Manual

Preventive Maintenance
• Press the Emergency STOP Button (ESB) and the treadmill
will coast to a stop. To release the emergency stop switch,
turn the push button ¼-turn in counter clockwise direction.
The treadmill will return to 0.0% elevation.
• Pull the Safety Tether System (STS) and the treadmill will
have a controlled stop. To re-attach the pull tether, attach
clip to the original position on the switch. The treadmill will
return to 0.0% elevation.

Weekly Maintenance

• Vacuum around and under the treadmill. Clean all exposed
surfaces with a vacuum cleaner. Avoid moving the treadmill
from its original position as moving it will compromise the
original belt tracking setting.
• Check running belt tension.
• Observe running belt tracking and correct as required.

Monthly Maintenance

Inspect and clean the running belt.

Semiannual Maintenance

• Evaluate the condition of the deck and running belt.
• Adjust the running belt to assure proper alignment.
• Check the running belt adjustment.
• Check the drive belt tension adjustment.
• Clean and lubricate the treadmill elevation screw.
• Clean the interior of the motor electrical enclosure as
needed.

Belt Cleaning and Inspection

1.
2.
3.
4.
5.
6.
58
Turn the treadmill main power switch ON.
Start treadmill at 0.5 mph (0.8 km/h).
With a damp small towel wipe excessive dirt from running
belt keeping the towel in the center of the length of the
treadmill. Avoid getting the towel near the rear roller.
When belt is clean, stop the treadmill.
Inspect the running belt for tears or nicks. If damaged,
replace the belt.
Perform the Running Belt Tracking Adjustment and Belt
Tension Adjustment.
T2100-ST1 Treadmill, 110V / T2100-ST2 Treadmill, 220V 2097937-002 Rev G
11 March 2019