Relocating The Esb And Sts Assembly - GE T2100-ST1 Service Manual

Component/FRU Removal and Replacement
10.
11.
3 AMP Fuse (BLK &
WHT Wires)
3 AMP Fuse (BRN &
BRN Wires)

Relocating the ESB and STS Assembly

Tools Required
o
o
o
o
1.
2.
3.
4.
146
Once all desired breakers have been replaced, reinstall the
plate with the (2) screws.
After installation, check the unit for proper operation.
1/8" Allen Wrench
¼" Flat Blade Screwdriver
2 Pair Long Nose Pliers
Grounding Wrist Strap
Approximate time to complete: 1 hr 00 min
Turn the treadmill main power switch to the OFF position.
Unplug the treadmill plug from the wall receptacle.
Allow the treadmill to discharge for 1 minute.
With the 1/8" Allen wrench, remove the (4) 10-32 screws
(Fig. A) holding the ESB and STS assembly to the fabricated
handrail.
Fig. A
10-32 Screw
ESB or STS
Assembly
T2100-ST1 Treadmill, 110V / T2100-ST2 Treadmill, 220V
Circuit Board
Mounting Plate
1/4 AMP Fuse (BLK &
RED Wires)
1/4 AMP Fuse (BRN &
BLUE Wires)
1/8" Allen Wrench
2097937-002 Rev G
11 March 2019