Advanced Control Tab - GE T2100-ST1 Service Manual

Calibration

Advanced Control Tab

Reset Treadmill: Select Reset Treadmill. The treadmill will perform
a software reset: it will return to 0.0% elevation and reset the
drive.
Load Defaults: Select Load Defaults to reset the speed calibration
to 0.000.
NOTE:
Load Pre-Calibration: Select Load Pre-Calibration to upload
calibration values.
NOTE:
Set PC Time: The FGLF0495-3 Smart Power Supply is equipped
with a real time clock. The time and date can be updated by
selecting Set PC Time to match the computer system. This will
assist when troubleshooting is required.
NOTE:
Runtime: Information indicating treadmill total runtime.
Firmware Version: Software version loaded in the smart power
supply board.
176
The treadmill needs speed calibration to start the running
belt.
Only to be performed when calibrating speeds fails, to
assist in troubleshooting.
The FGLF0495-1 Smart Power Supply is not equipped with
real time clock.
T2100-ST1 Treadmill, 110V / T2100-ST2 Treadmill, 220V 2097937-002 Rev G
11 March 2019