GE T2100-ST1 Service Manual page 99

treadmill down. Set switch configuration 1,2,3,4 and 6 are in the
"OFF" position and switch 5 is in the "ON" position.
Insert a blank micro SD card into IC3, then powerup the treadmill.
Depending on the number of records to be written, it can take up to
2 minutes to finish. When complete the treadmill begins to
initialization by turning the down relay on. Once that is done, power
the treadmill down and retrieve the micro SD card. Then reset the
switch configuration 1,2,4,5 and 6 are in the "OFF" position and
switch 3 is in the "ON".
NOTE:
The system flash log does not exist on FGLF0495-1 Smart
Power Supply.
2097937-002 Rev G
11 March 2019
T2100-ST1 Treadmill, 110V / T2100-ST2 Treadmill, 220V
Troubleshooting
99