Initial Setup - GE T2100-ST1 Service Manual

Assembly and Setup
• Do not attempt to move the treadmill with the handrails in
the shipping position due to the possibility of cutting the
internal wiring. You must either fully secure the handrails in
their proper position or secure handrails with 3/8-16 bolts
and 3/8 lock washers in the folded position.
• Lift the end of the bed assembly to a comfortable height,
keeping knees bent and back straight as you lift.
• Rotate the treadmill in the direction you want to go (the
treadmill will pivot on its wheels) and push forward.
When you have maneuvered the treadmill into its location,
•
gently lower the end of the bed assembly to the floor.

Initial Setup

Tools required for assembly:
• 5/16 Allen wrench (supplied)
The treadmill is shipped with the handrails loose, straddling the
treadmill frame. It is advised that you secure the handrails in
their proper location before removing the treadmill from the
base of the crate. This prevents the internal wires running down
the handrail mount to the motor pan from being cut.
1.
2.
1
2
36
amount of weight without causing strain or injury. If in
doubt, a second person should be recruited to assist.
If you are moving the treadmill over rough surface, such as
pavement, use a dolly under front of the treadmill to
prevent damage to the wheels and lift mechanism
Swing the handrail assembly into the operating position
and insert (2) 3/8-16 bolts and 3/8 lock washers on each
side and tighten securely.
Install (2) plastic caps each side for a finished look.
6
T2100-ST1 Treadmill, 110V / T2100-ST2 Treadmill, 220V
5
.
3
4
2097937-002 Rev G
11 March 2019