Replacing The Circuit Breaker - GE T2100-ST1 Service Manual

Replacing the Circuit Breaker

Tools Required
o
o
o
1.
2.
3.
4.
5.
6.
7.
8.
9.
2097937-002 Rev G
11 March 2019
1/4" Hex nut driver or flat blade screw driver
3/32" Flat blade electronic screwdriver
Grounding Wrist Strap
Approximate time to complete: 20 min
Turn the treadmill main power switch to the OFF position.
Unplug the treadmill plug from the wall receptacle.
Allow the treadmill to discharge for 1 minute.
Remove the (2) screws retaining the circuit breaker
mounting plate.
CAUTION:
Use ESD precautions, including wearing a grounding
wrist strap that is connected to an exposed metal
connection point on the treadmill chassis.
Gently pull the plate out, allowing the wires to feed through
the hole.
Unplug the (2) wire connectors from the circuit breaker to
be replaced.
When replacing more than one circuit breaker, perform the
replacement for one breaker at a time to keep the wires on
the correct value of circuit breaker.
Using a small electrical flat blade screwdriver, push in the
holding clips on the sides of the breaker to allow it to slide
out of the plate.
The clips are part of the breaker housing and are located
on the back side of the plate.
Install the new circuit breaker by sliding it into the hole
until it snaps into place.
Reattach the wire connectors by sliding them on to the
terminals.
T2100-ST1 Treadmill, 110V / T2100-ST2 Treadmill, 220V
Component/FRU Removal and Replacement
Nylon Screw & Standoff
Control Board Bracket
Control Board Nut
Control Board Screw
145