Elevation Calibration; Test Plug Check; Walking Belt Tension / Tracking; Walking Belt Speed Verification - GE T2100-ST1 Service Manual

Functional / Post Repair / Preventative Maintenance Checkout Procedures

Elevation Calibration

4.

Test Plug Check

5.

Walking Belt Tension / Tracking

6.

Walking Belt Speed Verification

7.
2097937-002 Rev G
11 March 2019
Perform the following elevation calibration and
verification:
a. Power on T2100-ST Series.
b. Perform the "Calibrating Elevation" procedure on
page 171.
Expected Results: The system elevation is successfully
calibrated without errors.
Perform the following tests.
a. Turn off and remove the controlling device from
back of treadmill.
b. Plug the Test Plug (secured to the frame) into the
RS232 port.
c. Perform the "Test Plug Procedure" on page 43.
d. When the unit passes the test, turn it off and
reconnect to controlling device.
Expected Results: The treadmill will elevate to 20%
with a cycled speed of 10 mph, and then return to 0%
and 0.0 mph.
Perform the following to check the walking belt
tension and tracking.
a. Power on the T2100-ST Series treadmill.
b. Adjust the speed manually by controlling the unit.
c. Perform the procedure "Running Belt Tension
Adjustment" on page 42.
d. Perform the procedure "Secure Cables
cables to ensure they do not get
e. Tie down
caught in the wheels or the elevation
racks.
Running Belt Tracking Adjustment
f.
page 42.
Expected Results: Belt should not slip and the rear
roller should have no alignment tracking problem.
Perform the following to check the walking belt
speed.
a. Power on T2100-ST Series
b. Adjust speed manually by controlling the unit.
c. Set speed to 5.0 mph/8.0 km/h.
Expected Results: 10 revolutions of the running belt in
15 seconds.
T2100-ST1 Treadmill, 110V / T2100-ST2 Treadmill, 220V
Pass/Fail
Pass/Fail
" on
Pass/Fail
Pass/Fail
183