Replacing The Deck Cushion; T2100-St1 Treadmill, 110V / T2100-St2 Treadmill, 220V 2097937-002 Rev G 11 March - GE T2100-ST1 Service Manual

Component/FRU Removal and Replacement
14.
15.
16.
17.
18.
19.
20.
21.
22.

Replacing the Deck Cushion

Tools Required
o
o
o
o
1.
2.
3.
4.
5.
6.
7.
8.
9.
138
Lift the edge of the running belt and slide the deck onto the
deck braces.
Replace the screws securing the deck to the deck braces
and tighten.
Verify the guide for the deck is to the left during
installation.
Tighten the cross brace securing bolts.
Use caution to avoid over tightening the bolts.
Align the bolt holes on the rear roller with the access hole
of the end caps.
Start the tensioning bolts on the rear roller but do not
tighten.
Replace the left and right end caps and the securing
screws.
Adjust the tension of the running belt.
See "Running Belt Tension Adjustment" on page 60.
Reinstall the hood.
¼" Allen Wrench or Socket
3/16" Allen Wrench or Socket
½" Wrench or Socket with extension
Jack stand or block capable of supporting the weight of the rear of
the treadmill
Approximate time to complete: 1 hr 00 min
Elevate the treadmill to 12%.
Turn the treadmill main power switch to the OFF position.
Unplug the treadmill plug from the wall receptacle.
Allow the treadmill to discharge for 1 minute.
Remove the (5) hood-securing bolts.
Remove the hood and set it aside.
Lift the rear of the treadmill and place jack stands or blocks
to support it.
With the 3/16" Allen wrench or socket, remove the bolt
securing the left and right end caps from the rear of the
treadmill.
Remove the end caps and set them aside.
T2100-ST1 Treadmill, 110V / T2100-ST2 Treadmill, 220V 2097937-002 Rev G
11 March 2019