Visual/Functional Checks; Operational Checks; Speed Calibration; March - GE T2100-ST1 Service Manual

Functional / Post Repair / Preventative Maintenance Checkout Procedures

Visual/Functional Checks

1.

Operational Checks

2.

Speed Calibration

3.
182
Perform the following inspections for visual signs of
excess wear or damage.
a. Check the device case for cracks or any other
visual damage.
b. Check plugs, cords, cable insulation jacket, and
connectors for bent prongs or pins.
c. Check handles for wear and or damage.
d. Check walking belt for wear and or damage.
Expected Results: No visual damage and wear
detected
Inspect the following to ensure they are operational.
a. Power Switch
o Connect T2100-ST Series to external power.
o
Power on the device
Expected Results: System powers on
b. Emergency Stop Switch
o
Power on T2100-ST Series
o Adjust speed manually by controlling the
unit.
o
Press the Emergency stop switch.
o
Release the Emergency Stop Switch.
Expected Results: Unit will coast to a stop;
running belt will move freely.
c. Safety Tether System
o Power on T2100-ST Series
o
Adjust speed manually by controlling the
unit.
o
Pull the Safety Tether System.
o
Replace the Safety Tether System.
Expected Results: Unit will have a controlled
deceleration to a stop; running belt will not move
freely.
Perform the following speed calibration and
verification:
a. Power on T2100-ST Series treadmill.
b. Perform the "Calibrating Speed" procedure on
page 168.
Expected Results: The system speed is successfully
calibrated without errors.
T2100-ST1 Treadmill, 110V / T2100-ST2 Treadmill, 220V
Pass/Fail
Pass/Fail
Pass/Fail
Pass/Fail
Pass/Fail
2097937-002 Rev G

11 March 2019